pH neutral Snow Foam cleans protected paint surfaces and removes dirt before washing, not the protective finish. This product can be applied with a pump sprayer (low foam) or with a foam lance. PH Neutral Snow Foam can be used to safely and effectively remove dirt films without fear of damaging delicate paints.
Foam Lance - For waxed or sealed paints, add 300ml Snow Foam and 700ml water to 1L Foam Lance or
adjust the amount of soap to the type of foamlance to be used. Foam the entire vehicle including wheel arches and rims. Leave on for 5 minutes. Then rinse thoroughly.
Pump Spray Method - Provides concentrated cleaning power for unwashed cars. Dilute 1:15 in heavily polluted conditions. Dilute 1:20 for lightly soiled cars.
Spray the lower part of the car, wheel arches and any areas where dirt and sand accumulate. Leave for 5 minutes. Then rinse thoroughly with a high-pressure cleaner.
Dilute 1: 5 to remove insect residue. Spray the affected area thoroughly with a pressure washer before flushing.
Note: This product will crash if stored at a temperature below 5ºC. If this happens, heat the product by storing it within hours or by placing the container in a bucket of hot water. This has no influence on the product nor on its effect.
Safety data sheet available on request for professional users.
Keep out of the reach of children
May cause allergic reactions